Juniper ACX7100-32C Hardware Manual page 73

The rear-mounting blades on each side of the chassis are movable. You can adjust the length of the
blades according to the depth of the rack.
Figure 24: Install the Rear-Mounting Blades on an ACX7100-32C Router
9. Install mounting screws into each of the rear-mounting bracket holes aligned with the rack, starting
from the bottom, and secure them tightly. Apply 5.0 to 5.5 lb-in of torque to the screws.
10. Visually inspect the alignment of the chassis.
If you've installed the chassis properly in the rack, all the mounting screws on one side of the rack
are aligned with the mounting screws on the opposite side, and the router is level.
page 65 shows the router fully secured and installed in a four-post rack.
Figure 25: ACX7100-32C Router Installed in a Four-Post Rack
RELATED DOCUMENTATION
ACX7100-32C Site Guidelines and Requirements | 32
Connect Earth Ground to ACX7100-32C Routers | 66
Figure 25 on
65