Perform Initial Software Configuration For The Acx7100-32C Routers - Juniper ACX7100-32C Hardware Manual

NOTE: Ensure that the 10-MHz or 1-PPS source network equipment contains low-voltage
complementary metal oxide semiconductor (CMOS) or is compatible with low-voltage (3.3 V)
transistor-transistor logic (TTL).
The ACX7100-32C supports a 1-Gigabit SFP grandmaster port (31). To configure port (31) as a 1-Gigabit
SFP grandmaster port you must use a QSA adapter to convert the QSFP28 port to a 1-Gigabit SFP port.
Perform Initial Software Configuration for the
ACX7100-32C Routers
Before you begin connecting and configuring an ACX7100-32C router, set the following parameter
values on the console server or PC:
• Baud Rate—9600
• Flow Control—None
• Data—8
• Parity—None
• Stop Bits—1
• DCD State—Disregard
You must perform the initial configuration of the ACX7100-32C router through the console port using
the command-line interface (CLI).
1. Connect the console port on the ACX7100-32C to a laptop or desktop PC using the supplied RJ-45
cable and RJ-45 to DB-9 adapter. The console (CON) port is the lower RJ-45 port on the right side
of the port panel.
NOTE: If your laptop or desktop PC doesn't have a serial port, use a serial-to-USB adapter
(not provided).
78