Juniper ACX7100-32C Hardware Manual page 54

Table 22: Cable Pinouts for 12-Fiber Ribbon Patch Cables
MPO Pin
6
7
8
9
10
11
12
12-Fiber Ribbon Breakout Cables with MPO-to-LC Duplex Connectors
You can use 12-fiber ribbon breakout cables with MPO-to-LC duplex connectors to connect a QSFP+
transceiver to four separate SFP+ transceivers—for example, 4x10GBASE-LR-to-10GBASE-LR, or
4x10GBASE-SR-to-10GBASE-SR SFP+ transceivers. The breakout cable is constructed out of a 12-fiber
ribbon fiber-optic cable. The ribbon cable splits from a single cable with a socket MPO connector on one
end, into four cable pairs with four LC duplex connectors on the other end.
Figure 18 on page 46 shows an example of a typical 12-fiber ribbon breakout cable with MPO-to-LC
duplex connectors (depending on the manufacturer, your cable might look different).
Figure 18: 12-Fiber Ribbon Breakout Cable
(Continued)
MPO Pin
7
6
5
4
3
2
1
46