Juniper ACX7100-32C Hardware Manual page 75

Figure 26 on page 67 shows the grounding points on ACX7100-32C routers.
Figure 26: Grounding Points on the ACX7100-32C Router
1 Grounding points
—
The grounding points are in the form of studs that are sized for #10-32 screws. (You need to provide
these screws with integrated washers as we do not ship them in the accessory kit).
You ground the router by connecting one end of a grounding cable to earth ground and then attaching
the other end to the chassis grounding points by using two #10-32 screws. You must provide the
grounding cables.
NOTE: The grounding lug required is a Panduit LCD10-10A-L or equivalent (not provided). The
grounding lug accommodates 14-10 AWG (2-5.3 mm²) stranded wire. The grounding cable that
you provide for the chassis must be the same size or heavier than the input wire of each power
supply. Minimum recommendation is 14-10 AWG (2-5.3 mm²) stranded wire for the
ACX7100-32C router
To ground the ACX7100-32C router:
1. Verify that a licensed electrician has attached the cable lug provided with the router to the grounding
cable.
2. Ensure that all grounding surfaces are clean and brought to a bright finish before grounding
connections are made.
3. Connect the grounding cable to a proper earth ground.
67