Connect Dc Power To An Acx7100-32C Router - Juniper ACX7100-32C Hardware Manual

9. Route the power cord appropriately. Verify that the power cord does not block the air exhaust and
access to router components, or drape where people could trip over it.
10. Power on the source power supply.
11. Repeat Step 3 through Step
Figure 29: Connect an AC Power Cord to an ACX7100-32C

Connect DC Power to an ACX7100-32C Router

Before you begin connecting DC power to the router:
• Ensure that you have taken the necessary precautions to prevent electrostatic discharge (ESD)
damage (see Prevention of Electrostatic Discharge Damage
• Ensure that you have connected the router chassis to earth ground.
CAUTION: Before you connect power to the router, a licensed electrician must attach
a cable lug to the grounding and power cables that you supply. A cable with an
incorrectly attached lug can damage the router (for example, by causing a short circuit).
To meet safety and electromagnetic interference (EMI) requirements and to ensure
proper operation, you must connect the chassis to earth ground before you connect it
to power. For installations that require a separate grounding conductor to the chassis,
use the protective earthing terminal on the router chassis to connect to the earth
ground.
• Install the PSM in the chassis.
Ensure that you have the following parts and tools available:
9 for the installing the remaining PSM.
).
71