Juniper ACX7100-32C Hardware Manual page 113

• Phillips (+) screwdriver, number 1
The ACX7100-32C supports two 100 GB Serial Advanced Technology Attachment (SATA) solid state
drives (SSD).The SSDs cannot be installed or removed when the system is up. You must shutdown the
system before replacing the SSD. The SSDs are preinstalled in the ACX7100-32C.
1. Place the antistatic bag or the antistatic mat on a flat, stable surface.
2. Wrap and fasten one end of the ESD grounding strap around your bare wrist, and connect the other
end of the strap to the ESD point on the chassis.
3. Remove the three captive screws securing the SSD cover plate by using the Phillips (+) screwdriver.
The SSD cover plate is located under the chassis (see
Figure 47: Removing the SATA SSD Cover Plate
Figure 49 on page 106).
105