Maintain The Acx7100-32C Transceivers And Fiber-Optic Cables; Remove A Transceiver - Juniper ACX7100-32C Hardware Manual

Maintain the ACX7100-32C Transceivers and Fiber-
Optic Cables
IN THIS SECTION

Remove a Transceiver | 95

Install a Transceiver | 97
Remove a QSFP28 Transceiver | 100
Install a QSFP28 Transceiver | 102
Remove a Transceiver
Before you remove a transceiver from a device, ensure that you have taken the necessary precautions
for the safe handling of lasers (see
Ensure that you have the following parts and tools available:
• An antistatic bag or an antistatic mat
• Rubber safety caps to cover the transceiver and fiber-optic cable connector
• A dust cover to cover the port or a replacement transceiver
The transceivers for Juniper Networks devices are hot-removable and hot-insertable field-replaceable
units (FRUs): You can remove and replace them without powering off the device or disrupting device
functions.
NOTE: After you remove a transceiver or when you change the media-type configuration, wait
for 6 seconds for the interface to display the operational commands.
Figure 43 on page 97 shows how to remove a QSFP+ transceiver. The procedure is the same for all
types of transceivers except the QSFP28 and CFP transceivers.
To remove a transceiver from a device:
1. Place the antistatic bag or antistatic mat on a flat, stable surface.
Laser and LED Safety Guidelines and Warnings
).
95