Juniper ACX7100-32C Hardware Manual page 158

If a grounding strap is not available, hold the component in its antistatic bag (see
150) in one hand and touch the exposed, bare metal of the device with the other hand immediately
before inserting the component into the device.
WARNING: For safety, periodically check the resistance value of the ESD grounding
strap. The measurement must be in the range 1 through 10 Mohms.
Avertissement Par mesure de sécurité, vérifiez régulièrement la résistance du bracelet
antistatique. Cette valeur doit être comprise entre 1 et 10 mégohms (Mohms).
• When handling any component that is subject to ESD damage and that is removed from the device,
make sure the equipment end of your ESD wrist strap is attached to the ESD point on the chassis.
If no grounding strap is available, touch the exposed, bare metal of the device to ground yourself
before handling the component.
• Avoid contact between the component that is subject to ESD damage and your clothing. ESD
voltages emitted from clothing can damage components.
• When removing or installing a component that is subject to ESD damage, always place it component-
side up on an antistatic surface, in an antistatic card rack, or in an antistatic bag (see
page 150). If you are returning a component, place it in an antistatic bag before packing it.
Figure 57: Placing a Component into an Antistatic Bag
Figure 57 on page
Figure 57 on
150