Table of Contents
Advertisement
NOTE: You must connect each PSM to a dedicated power source outlet.
To connect AC power to an ACX7100-32C router:
1.
Wrap and fasten one end of the ESD grounding strap around your bare wrist, and connect the
other end of the strap to the ESD point on the chassis.
2.
Power off the AC input appliance inlet on the source power supply.
3.
Connect the power cord to the power source outlet.
NOTE: Each power supply must be connected to a dedicated AC power feed and a
dedicated customer-site 2-pole circuit breaker. We recommend that you use a dedicated
customer-site circuit breaker rated for 20 A (110 VAC) or 16 A (220 VAC) minimum, or as
required by local code.
4.
Push the end of the AC power cord retainer strip into the hole next to the inlet on the power
supply faceplate on the router until it snaps into place. Ensure that the loop in the retainer strip
faces toward the power cord (see
Figure 28: Insert Power Cord Retainer Strip on the AC PSM
5.
Press the small tab on the retainer strip to loosen the loop. Slide the loop until you have enough
space to insert the power cord coupler into the inlet.
6.
Insert the power cord coupler firmly into the inlet.
7.
Slide the loop toward the PSM until it is snug against the base of the coupler.
8.
Press the tab on the loop and draw out the loop into a tight circle (see
Figure 28 on page
70).
Figure 29 on page
71).
70
Advertisement
Table of Contents
Troubleshooting
