Starting A Local Management Session; Figure 28: Connecting The Management Cable To The Console Port Of An X230 Series Switch - Allied Telesis AT-x230-10GP Installation Manual

Starting a local management session

AT-x230-10GP, AT-x230-18GP and AT-x230-28GP Switches Installation Guide
This procedure requires a terminal or a terminal emulator program and the
management cable that comes with the switch. To start a local
management session on the switch, perform the following procedure:
1. Connect the RJ45 connector on the management cable to the console
port on the front panel of the switch, as shown below.
F 28. C
IGURE ONNECTING THE MANAGEMENT CABLE TO THE CONSOLE PORT OF
230 S
AN X ERIES SWITCH
2. Connect the other end of the cable to an RS-232 port on a terminal or
PC with a terminal emulator program.
3. Configure the terminal or terminal emulator program as follows:
Baud rate: 9600 bps (The baud rate of the Console port is

adjustable from 1200 to 115200 bps. The default is 9600 bps.)
Data bits: 8

Parity: None

Stop bits: 1

Flow control: None

59