Figure 39: Management Workstation, Vt-Kit3 Management Cable, And Switch; Figure 40: Connecting The Management Cable To The Console Port - Allied Telesis x330-10GTX Installation Manual

Chapter 5: Verifying the Switch
To use the cable, you connect it to the Console port on the switch with a
standard, straight-through Ethernet cable. Refer to Figure 39. The cable
requires a software driver from Allied Telesis. The VT-Kit3 management
cable is sold separately.
Figure 39. Management Workstation, VT-Kit3 Management Cable, and
Switch
The following procedure explains how to start a local management
session on the switch. For instructions on how to start a remote
management session, refer to the x330 Series Software Reference for
AlliedWare Plus Operating System.
Perform the following procedure to start a local management session:
1. Connect the RJ-45 end of the management card included with the
switch to the Console on the switch. Refer to Figure 40.
Figure 40. Connecting the Management Cable to the Console Port
74