Starting A Local Management Session; Figure 45. Connecting The Management Cable To The Console Port Of Ags970M Series Switch - Allied Telesis CentreCOM GS970M Series Installation Manual

Starting a local management session

This procedure requires a terminal or a terminal emulator program and the
management cable that comes with the switch. To start a local
management session on the switch, perform the following procedure:
1. Connect the RJ45 connector on the management cable to the console
port on the front panel of the switch, as shown below.
F 45. C
IGURE ONNECTING THE MANAGEMENT CABLE TO THE CONSOLE PORT OF
GS970M S S
A ERIES WITCH
M A C A d d r
2. Connect the other end of the cable to an RS-232 port on a terminal or
PC with a terminal emulator program.
3. Configure the terminal or terminal emulator program as follows:
Baud rate: 9600 bps (The baud rate of the Console Port is

adjustable from 1200 to 115200 bps. The default is 9600 bps.)
Data bits: 8

Parity: None

Stop bits: 1

Flow control: None

C O N S O
L E
e s s L a b e l
S D
R S - 2 3 2
GS9790M Series Switch Installation Guide
1
3
S D
F A U L T
P O W E R
1 0 0 0 L IN
2
K
A C T
4
1 0 /1 0 0 L IN
K
A C T
5
6
73