Starting A Telnet Management Session; Figure 30: Connecting The Management Cable To The Rj-45 Terminal Port On The Switch - Allied Telesis AT-8100S/24C Installation Manual

Starting a Telnet
Management
Session
Figure 30. Connecting the Management Cable to the RJ-45 Terminal Port
2. Connect the other end of the cable to an RS-232 port on a terminal or
a personal computer with a terminal emulation program.
3. Configure the terminal or terminal emulation program as follows:
 Baud rate: Default is 9600 bps (Range is 9600 to 115200 bps)
 Data bits: 8
 Parity: None
 Stop bits: 1
 Flow control: None
Note
The port settings are for a DEC VT100 or ANSI terminal, or an
equivalent terminal emulator program.
4. Press Enter.
5. When prompted for a user name, go to "Changing the Stack ID
Number" on page 85.
Setting the stack ID number from a Telnet management session requires
Telnet client software on your computer. This procedure assumes that you
will be connecting your computer to a twisted pair port on the switch. To
start a Telnet management session on the switch using the factory IP
address:
1. Assign your management workstation the IP address 169.254.n.n, with
the subnet mask 255.255.0.0. The variable n can be from 1 to 255.
You may not use the switch's IP address 169.254.1.1. Refer to your
computer's documentation for instructions on how to set the IP
address.
Stack Installation Guide for 8100S Series Switches
on the Switch
83