Table of Contents
Advertisement
Changing a status parameter
To change a state parameter (COMMANDS menu):
- Press the E key when the parameter to be changed is displayed.
- A description of the current state (with inverted colors) is displayed.
- Press the ▲ and ▼ keys to switch the state among the available ones.
- Press E again to save the value of the parameter after it is changed.
- Press ESC to quit change mode without saving the value.
ALARM page
In the presence of an alarm, the ALM Led is activated and the ALARM page is automatically displayed, which shows the
details of the first alarm detected based on a set order of evaluation. Use the ▲ and ▼ keys to scroll the details of other alarms that may
be present..
When there are no more active alarms (because reset with the ACK key or because automatically reset), the ALM Led on the
ALARM page switches off and the HOME page is automatically displayed.
When exiting the page (for example, by pressing the HOME or MENU, key) with alarms still active (ALM Led on), you have to
press the ALARM key to return to the alarm page.
In the absence of alarms, the ALARM key does not change the current display in any way.
(1) Indication of progressive number of alarm and total number of alarms present
(2) Detail of variable and alarm bit
(3) Detail of zone in alarm (if not shown, alarm is global)
(4) Description of alarm
80997D_MSW_GFW_400-600_04-2021_ENG
91
Advertisement
Table of Contents
