gefran GFW 400-600A Configuration And Programming Manual page 86

This charter describes the optional GFW-OP keypad and use mode to display and program parameters:
Description
The program keypad is used to display the state and diagnostic parameters during operating period; on the back is present a ma-
gnetic material strip to fix it on GFW-master frontal or on a metal surface (ex. Electrical panel door).
The keypad is equipped with a connection cable of 70 centimeters.
Membrane keyboard
The following table describes the keypad and its functions:
Symbol Reference
ESCAPE
HOME
MENU
ALARM
RESET
ENTER
UP
DOWN
LEFT
RIGHT
86
KEYPAD USE
⇐
Signal led
⇐
Liquid crystal display
5 alphameric lines of
21 characters each
⇐
Pad keypad
Description
Comes back to the higher menu or submenu. Exits from a parameter, or a parameter list. Allows to exit
from a message requiring its use.
Access to home page (default page)
Access to menu page
Access to alarm page
Reset (acknoledge) alarms
Enters the submenu or the selected parameter, or selects an operation.
It is used during the parameter change to confirm the new set value.
Moves the selection in a menu or a parameter list highwards.
During a parameter change, increases the figure value under the cursor.
Moves the selection in a menu or a parameter list downwards.
During a parameter change, decreases the figure value under the cursor.
Comes back to top menu.
During a parameter change, moves the cursor verso rightwards.
Enters the submenu or the selected parameter.
During a parameter change, moves the cursor verso rightwards.
80997D_MSW_GFW_400-600_04-2021_ENG