Installing/Removing The Server Enclosure In/From The Rack - Fujitsu PRIMERGY CX400 M4 Operating Manual

5.2 Installing/removing the server enclosure
in/from the rack
V
CAUTION!
Please observe the safety information and notes on rack mounting in
●
chapter
At least two people are needed to install / remove the server
●
enclosure in the rack. (For Japan, please refer to " 安全上のご注意 ".)
Do not extend more than one unit out of the rack simultaneously even
●
if the tilt protection is in place. If several units are simultaneously
extended out of the rack, there is a risk that the rack could tip over.
Fujitsu rack systems
The rack systems from Fujitsu support the installation of PRIMERGY server
enclosures:
– PRIMECENTER rack
– PRIMECENTER M4 rack
– DataCenter rack
– 19-inch standard rack (for Japan)
– 19-inch slimline rack (for Japan)
I
For information on mounting the server enclosure in the rack please refer
to the mounting instructions provided in this section. Further information
see the manual of your rack system.
For Japan, please refer also to the "Rack system structure guide".
I
Online documentation for rack installation can be found on:
http://manuals.ts.fujitsu.com/index.php?id=5406-5605-5606
(for the global market)
http://jp.fujitsu.com/platform/server/primergy/manual/peri_rack.html
(for Japan).
To accommodate the ventilation concept and ensure proper ventilation, any
unused areas in the rack must be sealed using dummy covers.
The power is supplied via the multiple socket outlets fitted in the rack (for the
global market).
The main features of Fujitsu rack systems are as follows:
CX400 M4
"Important information" on page
Operating Manual
Hardware installation
21.
37