Figure 2-13: Indicator Leds - ARM DSTREAM-HT Getting Started Manual

DSTREAM-HT Getting Started Guide
• MIPI-34 adapter - This adapter connects directly to the front panel of DSTREAM-ST. The
adaptor is supplied with a MIPI-34 ribbon cable to provide debug and trace access to any
target with a MIPI-34 header.
• MIPI-60 adapter - This adapter plugs into a target's MIPI-60 socket and converts it to a
MICTOR socket for use with the DSTREAM-ST MICTOR adapter.
To obtain optional adapters,
Indicator LEDs on the top
When you power up the DSTREAM-ST unit, the LEDs on top of the unit indicate the status of the
unit.

Figure 2-13: Indicator LEDs

DSTREAM logo
The DSTREAM logo on the top of the unit illuminates and the STATUS LED begins to flash
when you power up the DSTREAM-ST unit. The DSTREAM logo also flashes when you
click the Identify button in the
Firmware Installer view
STATUS
Illuminates green to show that DSTREAM-ST is in its ready state.
Copyright © 2019, 2022 Arm Limited (or its affiliates). All rights reserved.
contact Arm support
Debug Hardware Configure IP view
in Arm Development Studio.
Non-Confidential
Document ID: 101760_1.0_02_en
with your requirements.
or the
Version 1.0
The DSTREAM-HT system
Debug Hardware
Page 17 of 39