Table of Contents
Advertisement
DSTREAM-HT Getting Started Guide
Connect and power up the DSTREAM-HT system
2.3 The DSTREAM-ST unit
The DSTREAM-ST unit provides the hardware interface to connect the host computer to your
target.
Rear
The rear of the DSTREAM-ST unit contains ports for connecting to the network, host PC, and the
power source. It also contains the RESET button and the USER IO port.
Figure 2-11: Rear of the DSTREAM-ST unit
Ethernet port
USB 3.0 port
Ethernet port
If you want to access your DSTREAM-ST unit over a local area network, use the Ethernet
port.
The green LED indicates that the Ethernet link is up and running. The yellow LED indicates
that activity is taking place. Supported data rates are: 10/100/1000 Mbps.
DSTREAM-ST is a Gigabit Ethernet (GbE) device. To achieve the maximum GbE data transfer
rate:
• Your PC must support the GbE standard.
• Your network infrastructure must support the GbE standard.
• You must use the included GbE cable.
USB 3.0 port
To connect the DSTREAM-ST unit directly to your host PC, use the USB 3.0 port.
DSTREAM-ST is a USB 3.0 device. To achieve the maximum USB 3.0 data transfer rate:
• Your PC must have a USB 3.0 port.
Copyright © 2019, 2022 Arm Limited (or its affiliates). All rights reserved.
on page 24
User IO port
Non-Confidential
Document ID: 101760_1.0_02_en
The DSTREAM-HT system
Reset button
Power input
Version 1.0
Page 14 of 39
Advertisement
Table of Contents
