Figure 2-15: Top Of Hsstp Trace Probe - ARM DSTREAM-HT Getting Started Manual

DSTREAM-HT Getting Started Guide

Figure 2-15: Top of HSSTP Trace probe

Host connector
Connects to the DSTREAM-ST unit using a 60-way ribbon cable. The Host connector also
controls the HSSTP probe and retrieves trace data from it.
Debug via HSSTP connector
Passes debug signals from DSTREAM-ST unit to the trace connector. When used, it connects
to the DSTREAM-ST unit using the Arm JTAG 20 cable.
If the target uses separate debug and trace connectors, the debug connection must be made
directly between the DSTREAM-ST unit and the target, leaving this connector, on the HSSTP
probe, unused.
HSSTP connector
Connects to the target trace connector via an HSSTP 40-way co-axial ribbon cable.
GbD connector
This connector is currently reserved, and is not used in Arm
Indicator LEDs
When you power-up the HSSTP probe, the LEDs on top of the unit indicate the status of the unit.
Status
At power-up, the Status LED:
Copyright © 2019, 2022 Arm Limited (or its affiliates). All rights reserved.
Non-Confidential
Document ID: 101760_1.0_02_en
The DSTREAM-HT system
® Development Studio.
Page 20 of 39
Version 1.0