ARM DSTREAM-HT Getting Started Manual page 25

DSTREAM-HT Getting Started Guide
▪ The USB cable, to connect the DSTREAM-ST unit directly to the host PC using the USB
3.0 port.
▪ The Ethernet cable, to connect the DSTREAM-ST unit to the network.
◦ To connect DSTREAM-HT to the target hardware, you need a target-compatible cable. For
a list of supplied cables, see
• If DSTREAM-HT or the target hardware are not earthed, potential differences
can occur between them. During connection, potential differences cause
unwanted pulses in the debug interface. This might also cause unwanted resets
to occur.
• When connecting the DSTREAM-HT system to target hardware, to avoid
damaging the target or debug hardware, ensure that the debug and trace
connector (or connectors) on the target use pinouts supported by DSTREAM-
HT. For supported pinout information, see the
Interface Design Reference
Procedure
1. Connect the DSTREAM-ST unit, the HSSTP probe, and the power supply unit:
a) Connect the DSTREAM-ST unit and the HSSTP probe using the 60-way AUX cable.
b) Attach the shorter 5V DC input end of the split power supply cable to the DSTREAM-ST
unit, and attach the longer 5V DC input end to the HSSTP probe.
Depending on your device arrangement, the 5V DC inputs are identical and
you can attach them to either the DSTREAM-ST unit or the HSSTP probe.
c) Attach the Power Supply Unit (PSU) to the PSU-adapter end of the split power supply
cable.
2. Connect the DSTREAM-ST unit to the host PC:
• If you are connecting using the USB port, connect the DSTREAM-ST unit to the host PC
using the supplied USB 3.0 cable.
◦
◦
• If you are connecting across an Ethernet network, connect the DSTREAM-ST unit to the
local network using the supplied Ethernet cable.
3. Power up the DSTREAM-HT system.
Copyright © 2019, 2022 Arm Limited (or its affiliates). All rights reserved.
Arm DSTREAM-HT box
Guide.
The USB drivers are provided with Arm Development Studio. For more
information, see the USB driver installation topics:
for the DSTREAM-HT system on Windows
the DSTREAM-HT system on
The DSTREAM-ST unit uses the Remote Network Driver Interface
Specification (RNDIS) to provide a virtual Ethernet link over USB. To
ensure your DSTREAM-ST unit is discoverable, enable the RNDIS
protocol in your network and firewall settings.
Non-Confidential
Document ID: 101760_1.0_02_en
contents.
Arm DSTREAM-HT System and
Install the USB drivers
or Install the USB drivers for
Linux.
Version 1.0
Set up your DSTREAM-HT
Page 25 of 39