Table of Contents
Advertisement
DSTREAM-HT Getting Started Guide
3.2 Install the USB drivers for the DSTREAM-HT system
on Linux
To use the DSTREAM-HT system with a USB connection, install the USB device drivers for
your operating system. The USB drivers for the DSTREAM-HT system are provided with Arm
Development Studio.
Before you begin
Ensure you have:
• Installed Arm Development Studio. For more information, see the
Getting Started
Guide.
• Administrative privileges on your PC.
Procedure
1. Using root privileges, run the
file that is available in the Arm Development Studio install directory. The
denotes the Arm Development Studio version that is installed on your PC.
2. To confirm the installation, enter
Results
The USB drivers are now installed on your PC.
Related information
Connect and power up the DSTREAM-HT system
3.3 Connect and power up the DSTREAM-HT system
Describes how to connect your DSTREAM-HT system to your host PC and target hardware.
Before you begin
• You must
install Arm Development Studio
configuration utilities.
• Your target hardware must have a debug connector supported by DSTREAM-HT. For a list of
supported connectors, see
Interface Design Reference Guide.
• You must have the following items from the
◦
The DSTREAM-ST unit.
◦
The HSSTP probe, with the 60-way AUX cable.
◦
The power supply unit, dual DC power cable, and the mains cable that is appropriate for
your region.
◦
To connect the DSTREAM-ST unit to the host PC or the network, you need either:
Copyright © 2019, 2022 Arm Limited (or its affiliates). All rights reserved.
run_post_install_for_Arm_Development_Studio_vx.x.sh
.
yes
on page 24
to access the software drivers and debug hardware
Target interface connectors
Arm DSTREAM-HT box
Non-Confidential
Document ID: 101760_1.0_02_en
Set up your DSTREAM-HT
Arm Development Studio
in the filename
x.x
in the Arm
DSTREAM-HT System and
®
contents:
Version 1.0
®
script
Page 24 of 39
Advertisement
Table of Contents
