Returning Tall Crop Feed Plates To Storage - MacDon R85 Operator's Manual

6.10.3 Returning Tall Crop Feed Plates to Storage

Follow these steps to install the tall crop feed plates:
DANGER
Stop engine and remove key from ignition before
leaving operator's seat for any reason. A child or
even a pet could engage an idling machine.
1. Lower the header fully.
2. Shut off the engine and remove the key.
3. Open the RH end drive cover.
Removing Right End Shield: North American Headers,
page 29.
4. Remove nuts (A) and secure the feed plates (B) to side
of compartment and remove plates. Reinstall nuts (A).
5. Install RH shield. See Section
End Shield: North American Headers, page
169457
OPERATING THE HEADER
See Section 5.4.3
5.4.4 Installing Right
29.
87
Figure 6.31
Rev. F