Table of Contents
Advertisement
Installing the DigiSuite VFW drivers in Windows NT
5. Follow the instructions that appear on the screen. An information
box indicates when Setup is complete.
Note
If your computer hangs when Setup scans your system for
installed cards, reboot your computer and run Setup again.
6. You must restart your computer in order for the changes to take
effect. To do so, click
Important
If you installed the DigiSuite VFW drivers, read the next
section for instructions on how to load the drivers into Windows NT.
DigiUtils Setup copies the DigiSuite VFW drivers onto your hard drive,
but does not add them to your list of installed drivers in Windows NT.
The following sections explain how to install the drivers in either
Windows NT 4.0 or 3.51.
Windows NT 4.0 installation
1. Choose
Start | Settings | Control Panel
Multimedia
icon, then click the
2. In the
Multimedia Properties
3. From the list of drivers, select
OK
.
4. In the
Install Driver
installed the drivers, such as C:\DigiSoft\DigiUtil\VFW.
5. In the
Add Unlisted or Updated Driver
DigiMotion Wave Driver
6. Control Panel returns you to the
Repeat steps 2 to 4.
7. In the
Add Unlisted or Updated Driver
DigiMotion/DigiMix VidCap-Codec
Windows NT 3.51 installation
1. Run Control Panel, double-click the
2. From the list of drivers, select
.
OK
3. In the
Install Driver
installed the drivers, such as C:\DigiSoft\DigiUtil\VFW.
Installing the DigiSuite VFW drivers in Windows NT
when prompted.
Yes
Devices
dialog box, click
Unlisted or Updated Driver
dialog box, type the path where DigiUtils Setup
, then click
.
OK
Multimedia Properties
, then click
Drivers
Unlisted or Updated Driver
dialog box, type the path where DigiUtils Setup
, double-click the
tab.
.
Add
, then click
dialog box, select
Matrox
dialog box.
dialog box, select
Matrox
OK
.
icon, then click
, then click
29
.
Add
Advertisement
Table of Contents
