Table of Contents
Advertisement
54
Changing an existing card set
Appendix A: Special Installation Instructions
Note
If you previously installed optional software components such
as DigiSuite ActiveMovie and DigiTools, make sure you select those
options again.
5. If you're installing more card sets, repeat the same procedures.
Installing two card sets that share one Movie-2 bus
Some DigiSuite card sets share a single Movie-2 bus connector. In this
case, each card set must also be installed one at a time, but this involves
removing the first card set to add the second one.
1. Install the hardware for Card Set 1 as explained in
"Installing the DigiSuite Hardware," on page
Movie-2 bus connector with only two cards attached.
2. Install the software for Card Set 1 by running the DigiUtils Setup
program as explained in
on page
25.
3. Remove the hardware for Card Set 1 and add Card Set 2 to the
Movie-2 bus.
4. Install the assembled hardware consisting of Card Sets 1 and 2
attached to their shared Movie-2 bus.
Note
Make sure Card Set 1 is reinstalled in the same slots as in
step
1
above.
5. Install the software for Card Set 2 by running the DigiUtils Setup
program again.
Before changing a card set by adding or removing cards, it's important
to save your card configuration settings to a .cfg file as explained on
page
35. After completing the hardware and software installation, you
can load the .cfg file to restore your settings.
If you have only one card set
1. Choose
UnInstall DigiUtils
folder.
2. Remove the card set hardware from your computer system paying
careful attention to the information in
bus—Important!" on page
Chapter 3, "Installing the DigiSuite Software,"
from the Matrox DigiSuite Utilities
"Take care of your Movie-2
20.
Chapter 2,
7. You can attach the
Advertisement
Table of Contents
