Table of Contents
Advertisement
Installing the Marvel Millennium drivers
If your system includes a Marvel Millennium card and you want to use
its "video in a window" capabilities with DigiSuite, you'll need to install
additional drivers as explained in the following steps.
Important
You may use only one Marvel Millennium card with
DigiSuite.
1. Install one of the following display drivers, depending on which
version of Windows NT you're using:
– NT 4.0:
MGA display driver version 3.12.046, located in the
Mga\Nt40 directory on the DigiSuite CD-ROM.
– NT 3.51: MGA display driver version 2.31.01, located in the
Mga\Nt351 directory on the DigiSuite CD-ROM.
For instructions on how to install the required display driver, refer to the
readme file in the directory where the driver is located.
in Control Panel and make sure your MGA display
2. Run
Display
properties are set to one of the following modes:
– 640 by 480 pixels or 800 by 600 pixels with Color Palette at:
• 32768 colors (15-bit), 65536 colors (16-bit), 16777216 colors
or True Color (24-bit or 32-bit).
– 1024 by 768 pixels with Color Palette at:
• 32768 colors (15-bit) or 65536 colors (16-bit).
3. Run Marvel Millennium Setup as explained in the next section.
Important
Each time you install a new MGA display driver, you must
run Marvel Millennium Setup.
Running Marvel Millennium Setup
The Marvel Millennium Setup program installs drivers required to use
your Marvel Millennium card with DigiSuite.
1. Close all Windows programs (except for Program Manager in
NT 3.51).
2. Insert the DigiSuite CD-ROM in your CD-ROM drive.
3. NT 4.0:
Choose
NT 3.51:
In Windows NT Program Manager, choose
4. In the resulting dialog box, type e:\marvelmillennium\setup (where
e: represents your CD-ROM drive), and click
Start | Run
.
Installing the Marvel Millennium drivers
File | Run
.
OK
.
31
Advertisement
Table of Contents
