Table of Contents
Advertisement
How DigiSuite software looks at your system
Installing more than one card set in a system
Another example would be a system with a DigiMix-DigiMotion card
set installed for nonlinear video editing, and another DigiMix installed
exclusively for character generation. In this case, the software would
recognize them as:
DigiMix-DigiMotion ................................................................. Card Set 1
DigiMix................................................................................... Card Set 2
Many combinations are possible to fill a lot of differing needs. For more
details, contact your Matrox dealer.
The first time you run DigiUtils Setup, the program looks at the DigiSuite
hardware installed in your system and stores this information in the
Windows NT registry. Because Setup must identify valid card sets one
at a time, it's important that you run Setup after installing each card set.
This way, the most recent information about the card sets present on your
system is stored in the Registry.
Setup identifies additional valid card sets installed in your system by
looking at what's been added to or removed from the previous stored
settings. This process must start with one card set to work properly.
When installing two or more card sets in a single computer system, it's
important to physically install each card set one at a time and run the
software setup program before installing the next one.
Important
If one of your card sets consists of DigiMix and DigiMotion,
install this first as Card Set 1. Most of the DigiSuite software such as
DigiTools and the DigiSuite Video for Windows drivers require that
DigiMix and DigiMotion be present as Card Set 1.
1. Install the hardware for Card Set 1 as explained in
"Installing the DigiSuite Hardware," on page
2. Install the software for Card Set 1 by running the DigiUtils Setup
program as explained in
on page
25.
3. Install the hardware for Card Set 2.
4. Install the software for Card Set 2 by running the DigiUtils Setup
program again.
Chapter 3, "Installing the DigiSuite Software,"
How DigiSuite software looks at your system
Chapter 2,
7.
53
Advertisement
Table of Contents
