Table of Contents
Advertisement
Before you begin
This section explains what you need to do to prepare your system for the
DigiUtils software installation.
Important
Make sure you've correctly installed your DigiSuite
hardware before attempting to install the software on your system. To
install more than one card set, you must run DigiUtils Setup after
installing each set. For details, see
Instructions."
Check for compatible versions of Windows NT
To run DigiUtils software, you must have installed either Windows NT
version 4.0 (Service Pack 2 is recommended), or Windows NT
version 3.51 with Service Pack 5. If you aren't sure whether an
appropriate Service Pack is installed, do the following:
q
In Windows NT 4.0, choose
(Common) | Windows NT Diagnostics
q
In Windows NT 3.51, choose
The resulting message box displays your Windows NT version number,
followed by the Service Pack that's presently installed on your system.
Check amount of free disk space
To install all the DigiUtils software, you'll need about 15 MB of free
space on your hard drive. If you don't have enough free space, delete
some files before running DigiUtils Setup.
The amount of disk space required by each of the optional components,
such as DigiSuite ActiveMovie and DigiTools, is displayed by DigiUtils
Setup at the time you choose which components you want to install.
Note
You should avoid installing any software on your system's A/V
drives as this may degrade system performance. If possible, use your
A/V drives exclusively for storing audio and video files.
Set Administration permission level
In order to install or remove any DigiSuite software, you must be
configured as an Administrator in Windows NT User Manager. For
details about the User Manager program, consult the appropriate
Microsoft documentation.
Appendix A, "Special Installation
Start | Programs | Administrative Tools
.
Help | About Program Manager
27
.
Before you begin
Advertisement
Table of Contents
