Table of Contents
Advertisement
34
Using the DigiSuite Configuration program
Chapter 4: Configuring Your DigiSuite Cards and VTR Settings
When you ran DigiUtils Setup to install the drivers for your DigiSuite
system, your cards were assigned default settings that are suitable for
most applications. The DigiSuite Configuration program lets you
customize these settings to meet specific video and audio input or output
requirements. For example, you may want to change the default proc amp
settings for your analog video input signal.
If you chose to install the VTR driver, you must use the DigiSuite
Configuration program to configure your VTR for device control with
DigiTools. This is required to perform frame-accurate capture and
recording to tape.
Important
Before starting the DigiSuite Configuration program, close
any program that uses DigiSuite, such as 3D Studio MAX. If you don't
do so, your system, video, and audio signals may become unstable.
Ë
To start the DigiSuite Configuration program:
q
In Windows NT 4.0, choose
double-click the
q
In Windows NT 3.51, run Control Panel and double-click the
icon.
DigiSuite
The DigiSuite Configuration window opens, similar to this one:
Start | Settings | Control Panel
icon.
DigiSuite
, then
Advertisement
Table of Contents
