Install Your Digisuite Cards - Matrox DigiSuite Installation Manual

Install your DigiSuite cards

Note Before proceeding, you should review the antistatic and safety
precautions described earlier on
1. Open your computer and identify the expansion slots in which you'll
install your DigiSuite cards. If any of the required slots already
contain cards, either move them to unused slots or remove them
completely.
2. Remove the metal plate located at the back of each slot you'll be
using. Don't lose the screws as you'll need them to fasten the cards
later on.
3. Determine the order of installation for the cards. This is indicated on
the top of the Movie-2 bus. You'll install the cards from right to left
when facing the back of the computer.
4. Remove each card from its antistatic bag. You should avoid touching
the chips and other components on the circuit boards. Try to handle
the cards by their edges.
5. Set your termination switches on DigiMix and/or DigiVid. See their
respective Installation Reference manuals for details.
6. Lay the card to be installed in the rightmost position on its side and
carefully install the Movie-2 bus as shown below. Insert the
mounting screw through the top of the Movie-2 bus and secure it to
the card.
page 9.
Install your DigiSuite cards
21