Uninstalling Digiutils; Changing Your Digisuite Hardware - Matrox DigiSuite Installation Manual

32

Uninstalling DigiUtils

Changing your DigiSuite hardware

Chapter 3: Installing the DigiSuite Software
5. Follow the instructions that appear on the screen. If you want to use
ActiveMovie programs with your Marvel Millennium, click
when asked if you want to install the DigiSuite ActiveMovie files.
6. You must restart your computer in order for the changes to take
effect. To do so, click
You can remove the DigiSuite Marvel Millennium software from your
system by choosing
Millennium folder.
You can remove all the DigiUtils software from your system as follows:
1. Do either one of the following:
– Choose
UnInstall DigiUtils
folder.
– Run DigiUtils Setup again, select
.
Next
2. When prompted, restart your computer for the changes to take effect.
Be aware that the DigiSuite VFW drivers will be removed from your
hard drive, but not from your list of drivers in Windows NT. For details
on how to remove drivers from Windows NT, refer to your Microsoft
documentation.
If you want to change your card set combination, such as by adding a
new DigiSuite card, you must first uninstall DigiUtils. Once you've
installed the new card set, run DigiUtils Setup again to update your
current installation.
For details on the procedure for installing multiple card sets and changing
your hardware installation, see
Instructions."
when prompted.
Yes
UnInstall Marvel Millennium
from the Matrox DigiSuite Utilities
Appendix A, "Special Installation
from the Marvel
UnInstall DigiUtils , then click
Yes