Table of Contents
Advertisement
Removing an entire card set
3. Install the new hardware combination for the card set as explained
in
Chapter 2, "Installing the DigiSuite Hardware," on page
4. Install the software for the new card set by running the DigiUtils
Setup program again. See
If you have more than one card set
1. Remove the hardware for the card set you wish to change from your
computer system paying careful attention to the information in
care of your Movie-2 bus—Important!" on page
2. Run DigiUtils Setup and choose
update settings stored in the NT Registry.
3. Install the new hardware combination for the card set as explained
in
Chapter 2, "Installing the DigiSuite Hardware," on page
4. Install the software for the new card set by running the DigiUtils
Setup program again.
When removing a card set, you have to completely remove the set and
then run DigiUtils Setup to update the NT Registry entries to reflect only
the remaining cards.
Note
If you're removing all DigiSuite hardware and no longer wish to
use your computer system for DigiSuite, uninstall the DigiUtils software
by choosing
UnInstall DigiUtils
folder.
"Running DigiUtils Setup" on page
Update the current installation
from the Matrox DigiSuite Utilities
Removing an entire card set
7.
28.
"Take
20.
to
7.
55
Advertisement
Table of Contents
Need help?
Do you have a question about the DigiSuite and is the answer not in the manual?
Questions and answers