Monitoring Battery Backup Units With Megaraid Storage Manager - LSI iBBU01 User Manual

Table 3.8 Set BBU Properties (Cont.)
Description Sets the BBU properties on the selected controller(s) after reading from the file. The
information displays in the following formats:
autoLearnPeriod = 1800Sec
nextLearnTime = 12345678Sec Seconds past 1/1/2000
learnDelayInterval = 24hours Not greater than 7 days
autoLearnMode = 0 0 – Enabled, 1 - Disabled, 2 – WarnViaEvent.
Note: You can change only two of these parameters, learnDelayInterval and
3.1.3 Monitoring Battery Backup Units with MegaRAID Storage
Manager
3-10
autoLearnMode.
MegaRAID Storage Manager software enables you to configure, monitor,
and maintain storage configurations on LSI
MegaRAID Storage Manager graphical user interface (GUI) makes it
easy for you to create and manage storage configurations.
When MegaRAID Storage Manager software is running, you can monitor
the status of all of the BBUs connected to controllers in the server. If a
BBU is operating normally, the icon looks like this:
red dot appears next to the icon.
To show the properties for a BBU, perform the following steps:
1. Click the Physical tab to open the physical view.
2. Select the BBU icon
3. Click the Properties tab.
The BBU properties, such as the battery type, temperature, and voltage,
appear, as shown in
Using the Battery Backup Units
Copyright © 2006-2009 by LSI Corporation. All rights reserved.
in the left panel.
Figure 3.4.
®
SAS controllers. The
. If it has failed, a