Monitoring Bbus With The Megaraid Configuration Utilities; Monitoring Bbus With The Webbios Configuration Utility; First Controller Properties Screen - LSI iBBU01 User Manual

3.1 Monitoring BBUs with the MegaRAID Configuration
Utilities
3.1.1

Monitoring BBUs with the WebBIOS Configuration Utility

3.1.1.1 Viewing Battery Backup Unit Information
3-2
This section describes how to use the MegaRAID utilities to monitor the
condition of installed BBUs. You can also use these utilities to reset the
recharge cycle counter to zero when you replace a battery pack.
The MegaRAID WebBIOS Configuration Utility (CU) configures disk
arrays and logical drives. Because the WebBIOS CU resides in the
BIOS, it is independent of the operating system.
If your SAS RAID controller has a battery backup unit (BBU), you can
view information about it. To do this, follow these steps:
1. Click Controller Properties on the main WebBIOS CU screen.
Figure 3.1 shows the first Controller Properties screen.
Figure 3.1

First Controller Properties Screen

2. Click Next to view the second Controller Properties screen.
Figure 3.2 shows the second Controller Properties screen.
Using the Battery Backup Units
Copyright © 2006-2009 by LSI Corporation. All rights reserved.