2.2.2.1
Connecting to the RAID Controller Using a Board-to-Board Connector
(Daughtercard)
2-12
–
MegaRAID SAS 8888ELP
Figure 2.7
shows the top view and the bottom view of the iBBU05, the
M2.50-0.45 x 5mm screws, and the 6mm standoffs. (The "top" side is the
side that you can see after you install the iBBU05 on the RAID
controller.) The iBBU05 combines a battery pack with a daughtercard.
Figure 2.7
Intelligent Battery Backup Unit 05
–
1 - J3 Battery Pack Harness Connector
–
2 - Battery Pack Harness
–
3 - J1 Connector
–
4 - J2 Board-to-board Connector
The first method for connecting the iBBU05 is to mount it directly to the
RAID controller using a small board-to-board connector known as a
daughtercard. Follow the steps in this section to install the iBBU05 on
the SAS 8704ELP or SAS 8708ELP.
If the RAID controller is already installed in a computer, follow these
steps to remove it before you install the iBBU05:
Installing the Battery Backup Units
Copyright © 2006-2009 by LSI Corporation. All rights reserved.