Installing The Lsiitbbu03 In The Minidimm Socket On The Megaraid Sas 8888Elp Raid Controller - LSI iBBU01 User Manual

2-30
5. Place the RAID controller on a flat, clean, static-free surface, and
continue with the next section.
Follow these steps to install the iTBBU03 on the SAS 8888ELP RAID
controller.
1. Ground yourself, and remove the iTBBU03 and the daughtercard
from the package.
2. Insert the J1 battery pack harness connector at the end of the 5-pin
cable into the 5-pin connector in the opening in the corner of the
iTBBU03.
3. Place the SAS 8888ELP on a flat, clean, static-free surface, with the
front side up.
4. Mount the iTBBU03 in the MiniDIMM memory socket on the RAID
controller as you would a standard DIMM, as shown in
The memory socket is mounted flush with the RAID controller so that
the iTBBU03 is parallel to the RAID controller.
Figure 2.20 Installing the LSIiTBBU03 in the MiniDIMM Socket on
the MegaRAID SAS 8888ELP RAID Controller
5. Press the iTBBU03 firmly into the memory socket.
Installing the Battery Backup Units
Copyright © 2006-2009 by LSI Corporation. All rights reserved.
Figure 2.20.