LSI iBBU01 User Manual page 32

2-16
customize the location of the remote battery to provide the most flexibility
within various environments.
Follow these steps to install the iBBU05 remotely.
1. Ground yourself, and remove the iBBU05 from the package.
2. Use the three Phillips-head screws that are provided to secure the
iBBU05 to the motherboard or server chassis.
3. Insert the battery pack harness connector at the end of the 5-pin
cable into the J3 connector on the backside of the iBBU05.
4. Connect the J1 connector on the iBBU05 to the J10 battery backup
connector on the backside of the SAS 8888ELP RAID controller, as
shown in Figure
There are black triangles on the connectors to help you install them
properly. Insert the cable connectors into the controller connector
and the iBBU connector so that the black triangles are aligned, as
shown in Figure
Installing the Battery Backup Units
Copyright © 2006-2009 by LSI Corporation. All rights reserved.
2.10.
2.10.