Installing The Lsiibbu01 On The Megaraid Sas 8888Elp Raid Controller - LSI iBBU01 User Manual

2-4
Follow these steps to connect the iBBU01 remotely to the SAS 8888ELP
RAID controller.
1. Ground yourself, and remove the iBBU01 from the package.
2. Use the three Phillips-head screws that are provided to secure the
iBBU01 to the motherboard or server chassis.
3. Insert the battery pack harness connector at the end of the 5-pin
cable into the J2 connector on the backside of the iBBU01.
4. Connect the 12-inch cable from the J1 connector on the iBBU01 to
the J10 battery backup connector on the back of the SAS 8888ELP
controller, as shown in
Figure 2.2 Installing the LSIiBBU01 on the MegaRAID SAS
8888ELP RAID Controller
Installing the Battery Backup Units
Copyright © 2006-2009 by LSI Corporation. All rights reserved.
Figure 2.2.