Start Bbu Learning Cycle; Place Battery In Low-Power Storage Mode; Set Bbu Properties - LSI iBBU01 User Manual

Table 3.5 Display Current BBU Properties (Cont.)
Description Displays current properties of the BBU. The information displays in the following
formats:
BBU Properties for controller: x
Auto Learn Period: xxx Sec
Next Learn Time: xxxx Sec
Learn Delay Interval: xx Hours
Auto-Learn Mode: Warn via Event/Disabled/Enabled
3.1.2.6

Start BBU Learning Cycle

Table 3.6 Start BBU Learning Cycle
Convention
CmdTool -AdpBbuCmd -BbuLearn -aN|-a0,1,2|-aALL
Description Starts the learning cycle on the BBU. No parameter is needed for this option.
3.1.2.7

Place Battery in Low-Power Storage Mode

Table 3.7 Place Battery in Low-Power Storage Mode
Convention
CmdTool -AdpBbuCmd -BbuMfgSleep -aN|-a0,1,2|-aALL
Description Places the battery in Low-Power Storage mode. The battery automatically exits this
state after 5 seconds.
3.1.2.8

Set BBU Properties

Table 3.8 Set BBU Properties
Convention
CmdTool -AdpBbuCmd -SetBbuProperties -f<fileName> -aN|-a0,1,2|-aALL
Use the command in
selected controller(s). A learning cycle is a battery calibration operation
performed by the controller periodically (approximately every three
months) to determine the condition of the battery.
Use the command in
Storage mode on the selected controller(s). This saves battery power
consumption.
Use the command in
controller(s) after reading from the file.
Copyright © 2006-2009 by LSI Corporation. All rights reserved.
Table 3.6 to start the BBU learning cycle on the
Table 3.7 to place the battery into Low-Power
Table 3.8 to set the BBU properties on the selected
3-9