LSI iBBU01 User Manual page 23

1. Shut down the computer, turn off the power, and unplug the power
cords.
2. Remove the cover from the computer according to the instructions in
the system user's manual so you can access the RAID controller.
3. Ground yourself before touching the RAID controller.
4. Unplug all cables from the RAID controller, remove the screw
attaching the bracket to the computer case, and carefully remove the
RAID controller from the slot.
5. Place the RAID controller on a flat, clean, static-free surface, and
continue with the next section.
Perform the following steps to mount the iBBU05 directly to the RAID
controller using the daughtercard. (All components are installed on the
bottom of the card. The battery is installed on the top. The maximum
height of components installed on the iBBU05 is 0.125".)
1. Ground yourself, and remove the iBBU05 daughtercard from the
package.
2. Insert the battery pack harness connector at the end of the 5-pin
cable into the 5-pin J2 connector on the backside of the iBBU05.
3. With the RAID controller on a flat, clean, static-free surface, hold the
iBBU05 daughtercard so that the battery side is up, and the J14
board-to-board connector lines up with the J7 BBU connector on the
RAID controller, as shown in
Copyright © 2006-2009 by LSI Corporation. All rights reserved.
Figure 2.4.
2-7