LSI iBBU01 User Manual page 40

2-24
– 3 - J2 Connector
– 4 - Battery Pack Harness
The iBBU07 mounts directly to the RAID controller using a small board-
to-board connector known as a daughtercard. Follow the steps in this
section to install the iBBU07 on the SAS 8880EM2 RAID controller.
If the RAID controller is already installed in a computer, follow these
steps to remove it before you install the iBBU07:
1. Turn off the power to the computer, and unplug the power cords.
2. Remove the cover from the computer according to the instructions in
the system user's manual so you can access the RAID controller.
3. Ground yourself before touching the RAID controller.
4. Unplug all cables from the RAID controller, remove the screw
attaching the bracket to the computer case, and carefully remove the
RAID controller from the slot.
5. Place the RAID controller on a flat, clean, static-free surface, and
continue with the next section.
Follow these steps to install the iBBU07 on the SAS 8880EM2 RAID
controller.
1. Ground yourself, and remove the iBBU07 daughtercard from the
package.
2. Insert the battery pack harness connector at the end of the 5-pin
cable into the 5-pin J4 connector on the backside of the iBBU07.
3. Place the RAID controller front-side up on a flat, clean, static-free
surface.
4. Hold the iBBU07 daughtercard so that the battery side is up and the
J5 connector lines up with the J1 BBU connector on the RAID
controller, as shown in
Installing the Battery Backup Units
Copyright © 2006-2009 by LSI Corporation. All rights reserved.
Figure 2.16.