Installing The Lsiibbu07 Daughtercard On The Megaraid Sas 8880Em2 Raid Controller - LSI iBBU01 User Manual

Figure 2.16 Installing the LSIiBBU07 Daughtercard on the
MegaRAID SAS 8880EM2 RAID Controller
J1
5. Carefully press the iBBU07 onto the RAID controller, so that the two
connectors are firmly joined.
Secure the iBBU07 to the RAID controller with the screws and the
standoffs in the three screwholes.
The standoffs are threaded at both ends and a screw goes into each
end.
6. Use the Phillips-head screws that are provided to secure the iBBU07
to the RAID controller, as shown in
Caution: Center the screwdriver carefully to avoid stripping the
screwhead. Do not over-tighten the screws.
7. Install the SAS 8880EM2 RAID controller in the computer in the PCI
Express slot, as shown in
Press down gently, but firmly, to ensure that the RAID controller is
correctly seated in the slot. The bottom edge of the RAID controller
must be flush with the slot.
Caution: Never apply pressure to the iBBU07 when you insert the
RAID controller. Instead, press down only on the top edge
of the RAID controller, as shown in
Copyright © 2006-2009 by LSI Corporation. All rights reserved.
Figure 2.16.
Figure 2.17.
Figure
85021-03
2.17.
2-25