Battery Module Screen - LSI iBBU01 User Manual

3-4
Figure 3.3

Battery Module Screen

Most of the Battery Module properties are view-only and are self-
explanatory.
In the lower right corner of the screen are the auto learn options. A
learning cycle is a battery calibration operation performed by the
controller periodically to determine the condition of the battery. You
can change the learn delay interval (the length of time between
automatic learning cycles) and the auto learn mode.
Note: LSI recommends leaving the the learn delay interval and
the auto learn mode at their default settings.
– Setting the Learn Delay Interval
The learn delay interval is the length of time between automatic
learning cycles. Perform the following steps to change the interval:
1. Open the drop-down menu in the Auto Learn Mode field.
2. Select the learn mode as Auto (the default).
This is so the controller performs the learning cycle automatically.
3. Change the number of hours in the Learn Delay Interval field.
Using the Battery Backup Units
Copyright © 2006-2009 by LSI Corporation. All rights reserved.