Figure 2.19 LSIiTBBU03 Intelligent Battery Backup Unit
–
1 - J1 Battery Pack Harness Connector
If the SAS 8888ELP RAID controller is already installed in a computer,
follow these steps to remove it before you install the iTBBU03:
1. Shut down the computer, turn off the power, and unplug the power
cords.
2. Remove the cover from the computer according to the instructions in
the system user's manual so that you can access the RAID
controller.
3. Ground yourself before touching the RAID controller.
4. Unplug all cables from the RAID controller, remove the screw
attaching the bracket to the computer case, and carefully remove the
RAID controller from the slot.
Copyright © 2006-2009 by LSI Corporation. All rights reserved.
2-29