LSI iBBU01 User Manual page 35

– 4 - Battery Pack Harness
The iBBU06 mounts directly to the RAID controller using a small board-
to-board connector known as a daughtercard. Follow the steps in this
section to install the iBBU06 on the SAS 8704EM2 or 8708EM2 RAID
controller.
If the RAID controller is already installed in a computer, follow these
steps to remove the RAID controller before you install the iBBU06:
1. Turn off the power to the computer, and unplug the power cords.
2. Remove the cover from the computer according to the instructions in
the system user's manual so you can access the RAID controller.
3. Ground yourself before touching the RAID controller.
4. Unplug all cables from the RAID controller, remove the screw
attaching the bracket to the computer case, and carefully remove the
RAID controller from the slot.
5. Place the RAID controller on a flat, clean, static-free surface, and
continue with the next section.
Follow these steps to install the iBBU06 on the SAS 8704EM2 or
8708EM2 RAID controller.
1. Ground yourself, and remove the iBBU06 daughtercard from the
package.
2. Insert the battery pack harness connector at the end of the 5-pin
cable into the 5-pin J4 connector on the backside of the iBBU06.
3. Place the RAID controller front-side up on a flat, clean, static-free
surface.
4. Hold the iBBU06 daughtercard so that the battery side is up and the
J5 connector lines up with the J10 BBU connector on the RAID
controller, as shown in
Copyright © 2006-2009 by LSI Corporation. All rights reserved.
Figure 2.12.
2-19