Installing The Lsiibbu05 Daughtercard On The Megaraid Sas 8708Elp Raid Controller - LSI iBBU01 User Manual

2-8
Figure 2.4 Installing the LSIiBBU05 Daughtercard on the
MegaRAID SAS 8708ELP RAID Controller
4. Carefully press the iBBU05 onto the RAID controller, so that the two
connectors are firmly joined.
5. Use the Phillips-head screws that are provided to secure the iBBU05
to the controller with the M2.50-0.45 x 5mm screws, and the 6mm
standoffs in the three screwholes.
The standoffs are threaded at both ends and a 6mm screw goes into
each end.
Important: Center the screwdriver carefully to avoid stripping the
screwhead. Do not over-tighten the screws.
6. Install the controller in the computer in the PCI Express slot, as
shown in Figure
Press down gently but firmly to seat the card correctly in the slot. The
bottom edge of the controller must be flush with the slot. Secure the
controller to the computer chassis with the bracket screw.
Important: Never apply pressure to the iBBU05 when you insert the
RAID controller. Instead, press down only on the top edge
of the RAID controller, as shown in
Installing the Battery Backup Units
Copyright © 2006-2009 by LSI Corporation. All rights reserved.
2.5.
Figure 2.5.