Tektronix ATECTekRanger User Manual page 49

Setups
Distance Units
Distance Units specifies measurements to be displayed on the screen
in meters, feet, or miles. Factory default is meters.
Distance is displayed on the horizontal scale under the waveform,
numerically at the top of each cursor, and in the event table columns.
Distance Units is user settable in all modes.
Test Port
Test Port specifies which Laser Output port option to use if two ports
(upper and lower) are installed.
Selections are Lower or Upper port. Factory default is Lower port.
Test Port is user settable in all modes.
This setup is not displayed if your instrument contains only one port.
TFS3031 TekRanger/TekRanger 2 User Manual
1–29