Tektronix ATECTekRanger User Manual page 116

Printing Files
Step 10. Print the file by pushing one of these softkeys:
Step 11. When finished, push the
2–48
content (the value of File Content setup when the file
was saved – see page 1–44).
When printing all files in storage, the Print Content setup
is ignored and only file content determines printer
output.
External Port
Select Parallel or Serial port. If the Seiko DPU411
printer is configured as described in step 1, select the
Parallel port.
Baud Rate
(Select 9600. Applies only if the Seiko DPU411 printer is
connected to the serial port).
Flow Control
(Select RTS/CTS. Applies only if the Seiko DPU411
printer is connected to the serial port).
When through changing printer setups, push the
softkey to resume the Print screen.
the printer
To stop printing the selected file before completion, push
the
printer off and on again before you can print another file.
Sends all files listed on the screen to the
printer.
To stop printing all files before completion, power off
the printer, and, in some cases, the TFS3031.
waveform/table screen.
TFS3031 TekRanger/TekRanger 2 User Manual
Sends the file selected on the screen to
softkey. You may have to power the
softkey to resume the