Tektronix ATECTekRanger User Manual page 38

Setups
NOTE. The setup screen last exited is the same one entered when you
push the
Step 2. Push the
Step 3. To cycle through the Test setups, push the
NOTE. In the Test Setup menu, setups enclosed in angle brackets
(< >) are adjusted automatically during the test by the TFS3031 in
order to achieve the best results. These setups are not user selectable.
Step 4. To cycle through the Fiber Scan parameters, push the
1–18
A setup field in mid screen that lists all the setups in a
menu. The currently selected setup is highlighted.
A change bar at bottom screen showing the currently
selected setup parameter and options. An arrow that
indicates more options may show on either end of the
change bar.
softkey.
setup menus (Test, Format, System, I/O–Doc).
button options are displayed in the lower right corner of the
screen.
Choose the Test Setup menu to continue with this example.
key repeatedly (or hold the key down).
Notice how the setups cycle in the setup field and change
bar.
Choose the Fiber Scan setup to continue. Fiber Scan sets
the test mode of the instrument.
or arrow key.
Notice how the parameters cycle in the setup field and
change bar.
TFS3031 TekRanger/TekRanger 2 User Manual
button repeatedly to cycle through the
or arrow