Power/Charger Adapter Port - Tektronix ATECTekRanger User Manual

Port Functions
Formatting a Floppy Disk
Both new and used floppy disks may have to be formatted.
Formatting destroys any data already on a disk.
To format a disk:
1. Insert an unformatted disk in the floppy disk drive.
2. Push the
TFS3031 checks the drive for a disk and determines if the disk
can be read. An unformatted disk cannot be read.
If the drive contains an unformatted disk, you are prompted to
format by pushing the
the
3. To format the disk, push the
A final yes/no confirmation prompt is displayed along with a
notice that formatting the disk will destroy any data already on it.
4. Push the
If you insert an unformatted disk while already in file storage, steps
2, 3, and 4 are displayed when you use the Save, Load, Copy, Delete,
or Print file options that involve accessing the floppy disk (when
toggling the

Power/Charger Adapter Port

and powers the instrument independent of the battery.
The battery must be charged before first use, and recharged when the
low-battery warning message is displayed on the screen. See page
3–2 for battery recharging instructions.
1–4
softkey to access file storage. The
softkey.
softkey again to confirm formatting.
The power/charger adapter port (2.5 mm DIN), located on
top of the TFS3031, connects to the power/charger
adapter and optional cigarette lighter adapter cable.
The power/charger adapter recharges the NiCad battery
TFS3031 TekRanger/TekRanger 2 User Manual
softkey, or not to format by pushing
softkey.
softkey).