Disconnect A Fiber-Optic Cable - Juniper QFX5200 Hardware Manual

CAUTION: Avoid bending fiber-optic cable beyond its minimum bend radius. An arc
smaller than a few inches in diameter can damage the cable and cause problems that
are difficult to diagnose.
Figure 64: Install a Transceiver
Ejector lever
1
—

Disconnect a Fiber-Optic Cable

Before you disconnect a fiber-optic cable from an optical transceiver, ensure that you have taken the
necessary precautions for safe handling of lasers. See
Ensure that you have the following parts and tools available:
• A rubber safety cap to cover the transceiver
• A rubber safety cap to cover the fiber-optic cable connector
Juniper Networks devices have optical transceivers to which you can connect fiber-optic cables.
To disconnect a fiber-optic cable from an optical transceiver installed in the device:
1. Disable the port in which the transceiver is installed by issuing the following command:
[edit interfaces]
interface-name disable
user@device# set
Laser and LED Safety Guidelines and Warnings
141
.